sign in
Progbox SKY programming card
Progbox SKY programming card
Progbox SKY programming card
Progbox SKY programming card
Progbox SKY programming card
Progbox SKY programming card
Progbox SKY programming card

Progbox SKY programming card

Available
€17.55

SkyRC Program Box is a very sophisticated electronic device that is controlled by a high performance microprocessor.

With compact size and easy operation, SkyRC Program Box offers six functions in one:

1. ESC Setup 4. Servo Tester
2. PC Interface - Link ESC to PC 5. Motor KV/RPM Checker
3. PPM Signal Monitor Input 6. LiPo Battery Monitor

 

VALID FOR ALL ESC SKY INVERTERS, BOTH 1/8 AND 1/10

Equipped with a 16Chr LCD screen. * 2 lines, the user interface is intuitive and easy to read. There are four keys on the front panel that can be used to operate the box for all functions. The ports for motor sensor, USB, I/O connector and battery balance connector located on the sides of the case are clear and easy to use.

ESC Settings

When we want to program the ESC precisely, we usually connect it to a PC. But sometimes, when you are driving on the circuit, it is not convenient to carry the PC, even the laptop. At this time, you can use this device as a programmer card to set all ESC parameters with maximum precision. Just plug it into the ESC and set all the parameters precisely in the short time you want.

ESC interface connection to PC

In addition, it can also work as SkyLINK, a USB adapter that can be used to connect the ESC with a PC, and you can update the firmware of the ESC or program the ESC by SkyLINK software on PC.

PPM signal monitor


The PPM signal monitor function allows you to check the receiver's output voltage and width and frequency of the radio's PPM signal.

Ā  Ā  Ā  Ā  Ā  Ā  Ā  Ā  Ā  Ā  Ā  Ā  Ā  Ā 

servo tester
You don't need to turn on your radio, you can easily check the function of the servo. Connect the servo to the Program Box, get the information of input voltage, servo travel position and maximum current. There are two modes: one is swing mode and the other is manual mode. Both modes are easy to operate.

Ā  Ā  Ā  Ā  Ā  Ā  Ā 

Motor KV/RPM tester

Wondering about engine information? Connect your motor to this small device, enter the initial setting, move the throttle of the transmitter, then you can read the value of the motor's KV, RPM and input voltage on the screen.

Lipo battery monitoring
It is also a very good device to check the situation of your LiPo battery anywhere and anytime. You can use it to check the total number of cells, the total voltage, the voltage of each cell, the highest voltage and the lowest voltage, and the voltage difference between the highest and lowest voltage.

Ā  Ā  Ā  Ā  Ā  Ā  Ā  Ā  Ā  Ā  Ā  Ā  Ā  Ā  Ā  Ā  Ā  Ā  Ā  Ā  Ā 

Ā  Ā  Ā 

Dimensions:

Input voltage (ESC configuration) 6-10VDC
Input Current (ESC Settings) 500mA
Idle current (ESC setting)
Work temperature 0-40ĀŗC
Storage temperature -10 — 60ĀŗC
Operating humidity range 10 - 90 %RH
Storage humidity range 20 - 75 %RH
Dust and water protection index IP20
Weight 40g

SK-300046

16 other products in the same category:

Product added to wishlist